Make sure that your hands are so shaky that the probe slips off BCM 18 and hits the 5v pin, letting out all the magic smoke. Place the prongs of your multimeter on 3v3 power pin and BCM pin 18.ĭon’t use alligator clips to keep your probe steady. Let’s say you have a button hooked up to your GPIO pins, but pressing the button does nothing and you can’t figure out why. Shorting the +3 Volt Pinįor this hack, you’ll need a Pi Model 3 B+ and a multimeter. Today I’ll show you three easy ways to turn a Raspberry Pi into a paperweight. I learned over the course of my first hardware project that, well, hardware is hard.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |